Show newer

@pganssle

At that point if you have an o-scope you might as well just put it right on the lead to the LED :)

@soundofsun

@soundofsun Yea the frequency could be high.. they may also dim via voltage rather than PWM, which will work for LEDs but many circuits use psm because its easier to control digitally.

So could be the one that doesnt give you a headache is analog dimmable and the one that does is PWM dimmable.

@soundofsun My guess would be that your LED floor lamp does diming? It is typical an LED dimmer uses whats called PWM to do the dimming which basically means it flickers at a higher frequency than you can see with a duty cycle that adjusts the brightness. The other devices sound like they are stead-on state.

@kohn@chaos.social These videos are always so disappointing, they never actually fall!

@cz35iek Its really great to have you here. Can't wait to follow your contributions.

Hello World! :ablobraisehand: Yet another programmer is joining this awesome community. I'm looking forward many interesting discussions.

Interesting fact of the day:

Meteores got their name because earlier scientists thought they were made out of hamburgers, so they were called "Meaty Ores". It wasn't until many decades later we discovered this wasn't true but by the then the name was already common place.

@seek I just noticed when I posted this the equations werent using the right format to render the latex. I have now fixed this.

Also, welcome to qoto, it is great to have you here.

So I just provided the answer to this Stackexchange question and I noticed something kinda cool and interesting in the final equation:

electronics.stackexchange.com/

The equation, for those of you on a Latex capable instance is:

\( k \cdot \frac{N_p}{N_s} \cdot \sqrt{\frac{L_s}{L_p}} = R_\phi\)

In this case R, the flux linking ratio, must be a value between 0 and 1 and represents the percentage of flux that is mutual between two coupled inductors (a transformer).

Similarly k is Coefficient of Coupling, which is also a ratio between 0 and 1. It is a different measure of how well coupled two inductors are.

What I find interesting about the equation is that all the other variables can be anything from 0 to infinity, so at first glance you would think that it would be possible to have a scenario where either R or k are greater than 1. But in reality because the number of windings of the primary and secondary have a reciprocal relationship to that of the square root of the ratio of the inductances, in reality any real world values that you could plug in here would actually never be able to produce a contradiction.

If you look at the equation to calculate the inductance of an inductor based on its number of turns this becomes obvious. for simplicity if we assume the diameter if the inductor and the wire thickness are all the same then the relationship is basically the following:

\( L = N^2 \cdot C \)

Where L is the inductance, N is the number of turns, and C is some constant. So essentially the square of the number of turns of the inductor is linearly proportional to its inductance. Going back to the equation I was talking about this basically counters the sqrt function in the equation and it becomes obvious why any real world values would always satisfy the equation correctly.

@twdockery Its not that armstrong mubundled it, its because static kicked in and you cant hear the word "a", which is why there is a small pause right where the word should be.

Show older
CleverLibre Social

CleverLibre Social is an inclusive social instance for open discussion, learning, and community.
All cultures welcome.
Hate speech and harassment strictly forbidden.