Show newer

@kranfahrer

One might expect that to be the case, but no, the arc doesnt behave that way (it does when there is no salt though).

My guess, and I had this theory before i tried the experiment so it partly proves me right, is that the conductivity of the salt in molten form would prevent that from happening. The plasma stays inside the hollow chamber surrounded by the liquid salt which helps channel it. It never rises due to an electrically conductive physical barrier.

@Science

@Science Finally I took apart the solid clumps to get a closer look. At first the two pictures are the solid clumps around the spark gap pretty much in tact. They were quire hard. Howeve however I noticed when i broke it in half (as well as the solid clump at the bottom of the beaker) it was in fact hollow in the middle and only the outside was solid.

It would appear the plasma has so powerful it vaporized the salt to a gas in the middle and only the area outside the path of the arc was solid. That is one hell of a plasma arc!

Show thread

@Science Here we can see in this run (second run not the one in the video) that the arc fomed a solid clump of salt around where the arc took place as well as a half-circle of solid sald at the bottom. The half-circle of solid salt at the bottom was fused to the clump that surrounded the location of the arc. It was impossible to get it out as one piece.

The important part to notice here is that the arc traveled through the solid (or rather molten at the time the microwave was going) salt and tried to find a path to ground. It was so powerful that it instantly cracked the lab-quality beaker it is held in and you can see a crack right at the same spot the paper bowl is burnt.

Amazing it went right through the glass like it was there.

Show thread

@Science Here we can see in this run (second run not the one in the video) that the arc fomed a solid clump of salt around where the arc took place as well as a half-circle of solid sald at the bottom. The half-circle of solid salt at the bottom was fused to the clump that surrounded the location of the arc. It was impossible to get it out as one piece.

The important part to notice here is that the arc traveled through the solid (or rather molten at the time the microwave was going) salt and tried to find a path to ground. It was so powerful that it instantly cracked the lab-quality beaker it is held in and you can see a crack right at the same spot the paper bowl is burnt.

Amazing it went right through the glass like it was there.

Show thread

@Science Here are pictures of me preparing the coil, then placing it in a 30ml beaker and covering it with salt. Few notes

1) I know it looks like a resistor, it isnt. Its a 0 ohm resistor so just the same as some wire.

2) I put a layer of salt down, then the spark gap coil then a layer of salt

3) The salt is potassium chloride because it has very fine grains.

Show thread

@Science Here are pictures of me preparing the coil, then placing it in a 30ml beaker and covering it with salt. Few notes

1) I know it looks like a resistor, it isnt. Its a 0 ohm resistor so just the same as some wire.

2) I put a layer of salt down, then the spark gap coil then a layer of salt

3) The salt is potassium chloride because it has very fine grains.

Show thread

So a while back i realized you can create an extremely high energy hot plasma in the microwave consistently by taking a coil and streching it out and forming it into a loop with one gap on the sad. The ark that forms has huge amount of energy in a very small space. In the past it has melted a blob of borisilicate glass almost instantly fuzing the coil i to the glass under neath.

It has a tendency to grow into a large cloud of blasma that rises to the top of the microwave usually. Since this ball plasma is much larger the energy is spread out. Despite still being extremely hot its nowhere near the heat of the initial ark as it takes some time to heat glass to its melting point in this state.

So i had an idea. What would happen if i contained the arc under a pile of salt, in this case potassium salt. It should keep the plasma contained and due to maintaining a very small volume should retain the enormous heat i figured it would be more than hot enough to melt the salt but i wanted to try it out.

Attached is the video in the microwave itself. I will reply to this thread with various stills before and after of the setup showing the final results

@Science

@realcaseyrollins

Clearly you have never seen my ungle on a beach. He scared away half the other people on the beach last time cause they thought a wild bear had gotten loose.

@Marbleturtle

@lupyuen the key will getting them spaced just right in the clay I think.. but if you do without much showing I think it might work nicely. Good luck.

@lupyuen this is what I was going to suggest, but the putty farther down. In fact. if you put it so far down only a mm or so of the wire leads produce from the bottom it should be able to rest on top comfortably. A low center of gravity plus less wire length so less bending I think should do the trick.

Honestly I'm surprised you dont just have a 2x row header you could use instead.

@lucifargundam then call 911. If they are choking and convulsing at the same time for entierly seperate reasons then I dont think there is much you could do other than to wait till the seizure is over and then address the choking. But at that point your best to call 911 and let them lead you through it.

@GirthyChode@fosstodon.org Generally if its a petite seizure there isnt much you need to do. Don't panic, they will just be a bit spacy or unresponsive for a bit. Best to just make sure they are safe and keep an eye on them.

For a grand mal seizure, where someone is convulsing, then you clear the space of anything hard or sharp they could get hurt on. Do not restrain them, let them convulse. But them on their side and try to keep them there to help keep their airways clear. Watch that they are breathing (they should be), and keep track of how long.

Also as always, call 911 if you have any doubts.

If you arent familiar with seizures (both grand mal and petite), or what to do if you witness one, then please take the time to learn. Seizures are fairly common and there is a good chance you may be around a friend or stranger int he future who has one and how you handle it can make a huge impact on their safety. That is all.

@NickolasGir well your still tagging me three times now since I ended the conversation. You really must be desperate for attention. Muting you now.

@NickolasGir I guess thats one way to respond to pulling numbers out of your ass then complaining about methodology from the one source of actual data you didnt see yet just because it disagrees with your assumption.

What are you like 12, grow up dude. I'm done with you.

Show older
CleverLibre Social

CleverLibre Social is an inclusive social instance for open discussion, learning, and community.
All cultures welcome.
Hate speech and harassment strictly forbidden.