Time to try #BL602 UART Flashing with BLOpenFlasher in #GoLang ... Because flashing from Windows is getting tiring

https://github.com/bouffalolab/BLOpenFlasher

Hmmm odd... Where do we specify the firmware to be flashed 🤔

Found the #BL602 Firmware to be flashed

https://github.com/bouffalolab/BLOpenFlasher/issues/2

#BL602 Device Tree that gets bundled into our firmware before flashing over UART 🤔

https://github.com/bouffalolab/BLOpenFlasher/blob/main/bl602/device_tree/bl_factory_params_IoTKitA_40M.dts

How #BL602 Firmware Files are transformed before flashing

https://github.com/bouffalolab/BLOpenFlasher/blob/main/flash_tool.go

While resting my hamstring ... Let's sketch the #BL602 Firmware Flashing Steps!

https://github.com/bouffalolab/BLOpenFlasher/blob/main/flash_tool.go

How #BL602 Firmware is flashed

https://github.com/bouffalolab/BLOpenFlasher/blob/main/flash_tool.go

Documenting the steps for Flashing #BL602 Firmware to #PineCone @PINE64

https://github.com/lupyuen/lupyuen.github.io/blob/master/src/flash.md

#BL602 Partition Table ... Tells us the ROM Layout

https://github.com/lupyuen/lupyuen.github.io/blob/master/src/flash.md

#BL602 EFuse Config ... With dead beef 😂

https://github.com/lupyuen/lupyuen.github.io/blob/master/src/flash.md

Can we flash #PineCone #BL602 ... From Arm64 #Pinebook Pro? Let's find out!

https://github.com/lupyuen/lupyuen.github.io/blob/master/src/flash.md

#PineCone #BL602 responds to #Pinebook Pro at 2 Mbps ... So far so good!

https://github.com/lupyuen/lupyuen.github.io/blob/master/src/flash.md

Flashing #PineCone #BL602 from #Pinebook Pro ... Fails with the same error that was previously reported ... Will retry with lower baud rate

https://github.com/bouffalolab/BLOpenFlasher/issues/2