Printed for fun and to see what some of the finest settings do on my new Ender 3 V2 Neo. PETG. 160x160mm base. Can anyone identify the location? @3dprinting #3dprinting
@idropyou I was thinking Mt St Helens, but that long ridge line doesn't look right. Does look like an old volcano eruption point though. Nice print!
@jerzone It's on this continent :)
@idropyou Wind River range in Wyoming?
@idropyou Not in Wisconsin, right? 😄
I had the Cirque of the Towers 3D printed a couple years ago, but sent that to my sis. Don't think it has that big flat spot in the middle though.
Here's the location. One of my happy places. https://goo.gl/maps/iLeLDdnK2akUnAf7A
@idropyou I've been on the going to sun rd a couple times, looks like I was close by.
@jerzone Camping in Many Glacier is great. Did a few hikes off GTSR, one was from Jackson Glacier Overlook back to the campground over Piegan Pass....the south side of that print. Amazeballs. I think it was 15.x miles. Have a goal to get back there and do the 20 mile one way Gunsight Pass hike to Lake MacDonald.
@idropyou Took wife out west after we got married (a few decades ago!) and we tented at the campground down the road. On our walk back from getting some breakfast a bear was shadowing us on the other side of the road for a bit then disappeared into woods.
"hmm, not sure if we should cross or not"